Order ST-W48 Sith Trooper Blaster

Item Features:

!!!NOT A REAL GUN, THIS IS A PROP REPLICA!!!

This is a 3D printed Kit.
Colors may vary from picture.
Printed on original Prusa printers to ensure quality.
Will require minimal amount of post processing work.
This is not a finished gun and requires some assembly, sanding, and painting.

The ST-W48 blaster was a blaster used by the Sith troopers of the Sith Eternal's Final Order, including the trooper ST-I4191. The weapon could be used in a blaster rifle configuration or a blaster carbine configuration where the stock was removed for use in confined spaces. Each ST-W48 had a quarrel-bolt launcher installed below its barrel order that used enhanced bowcaster technology for a powerful explosive attack. The rifle's power cell cartridge was located around the mid-point of the weapon's length, above the trigger.

During the battle of Exegol, the climactic confrontation in the First Order's war against the Resistance, many Sith troopers fought using ST-W48 blasters.



Includes:

All parts printed necessary to assemble one blaster
Orange barrel or tip as required by law

Not Included:
hardware and glue

--Legal Notice--
This is not an officially licensed product and is only considered FAN ART, the item is 3D printed by me. Fan Art is protected under Fair Use.

§ 272.3 Approved markings.

The following markings are approved by the Secretary of Commerce:

(a) A blaze orange (Fed-Std-595B 12199) or orange color brighter than that specified by the federal standard color number, solid plug permanently affixed to the muzzle end of the barrel as an integral part of the entire device and recessed no more than 6 millimeters from the muzzle end of the barrel.

(b) A blaze orange (Fed-Std-595B 12199) or orange color brighter than that specified by the Federal Standard color number, marking permanently affixed to the exterior surface of the barrel, covering the circumference of the barrel from the muzzle end for a depth of at least 6 millimeters.